Tap-Offs, Traps and Attenuators from Warren Electronics

FM Traps

25dB FM TRAP

25dB Fixed FM trap designed to attenuate the entire

FM band. AC/DC passive. UHF passive. Housed in a rugged plastic weatherproof housing for mounting on antenna mast or boom. 300 ohm Input and output connections. With mounting bracket and hardware. Not recommended for receiving TV Channel 6.

Winegard model FT-3000

VARIABLE FM TRAP

Two stage variable FM trap. When both stages are tuned to a single frequency, it will be attenuated 26 dB or about 1/20 of its previous level. When each stage is tuned to a different frequency, it will be reduced from 7 to 10 dB or 1/2 to 1/3 of the original level. Used to reduce strong signals from local FM stations and prevent overload of amplifier and TV sets. Unit is enclosed in weatherproof housing for mounting on antenna boom, mast or wall. Will pass power to antenna-mounted preamplifier. Mounting hardware, F-connectors included. (Adjusting this trap requires the use of a scope, analyzer, or signal level meter to tune accurately.) Not recommended for use on TV channel 6. Winegard model FT-7600

UHF Traps

ADJUSTABLE UHF TRAP

Trap may be tuned over the frequency range

of 470 to 810 MHz. Features two separate traps.

Both may be tuned to the same frequency to

reduce it -15 dB, or separate frequencies to

reduce 8.5 dB. Can be mounted indoors or out.

Passes VHF frequency; AC/DC passive.

(Tunable traps require the use of a scope,

analyzer, or signal level meter to tune accurately)

Winegard model UT-2700

Specific Channel Filters

Channel 4 filter

Filter passes channel 4 from satellite receiver or VCR

and eliminates all other channels which may pass

through the satellite receiver or VCR when not in use.

Coupling input provided for antenna where adjacent

channels are not present. Not AC/DC passive.

Supplies limited. Winegard model VF-4000

Satellite Taps

2 way 12dB tap

2 way 12dB tap. 40-2050mhz

Trunk DC pass, taps DC block

Channel Master model 1212IFD

Supplies limited

Directional Tap-Offs

Directional Line Tap-Off

Directional line tap-off. 5-400mhz.

14dB. Channel Master model 7111

Directional Line Tap-Off

4 way directional line tap-off. 5-900mhz.

12dB. Model DCWG-12

Directional Line Tap-Off

VHF/FM directional line tap-off.

20dB. Channel Master model 7129

Directional Line Tap-Off

VHF/FM directional line tap-off.

25dB. Channel Master model 7130

Back-Matched Line Tap-Off

UHF/VHF/FM back-matched line tap-off.

1 tap. 17dB. Channel Master model 7228

Back-Matched Line Tap-Off